banner

Product

  • pic
  • pic
  • pic
  • pic

Product Name YET401AC receiver with bluetooth function

YET401AC receiver with bluetooth function


Product Specification:

  • Voltage:AC220V OR DC12V
  • Quiescent Current:≤30mA
Inquiry Now

Want create site? Find Free WordPress Themes and plugins.

 

Product specification

Voltage AC220V  OR  DC12V
Quiescent Current ≤30mA
Temperature -40℃ ~ +80℃
Receiver sensitivity ≥-105dBm
Frequency 433MHz 、2.4G(BLE)
Contact current ≤1A
Memory capacity 30pcs remote control
Size 115mm*70mm*32mm

 

Remote operation instructions

Pair code: Press the button on the controller, the indicator light is on, indicating that the code can be started. Press and hold the remote control button for a long time. The indicator light flashes to indicate success.

Clear code: Press the button on the controller, the indicator light is on, indicating that the clear code can be started, long press the remote control off button, the indicator light flashes to indicate success.

Remote control button:
Off Key – Off
Unlock button — open

Mode selection:
The jumper cap is in the M position: Each time the button is pressed, the switch status changes.
The jumper cap is in the L position: Each press opens to open, press to close.
The jumper cap is in the 3S position: each press opens to open, and press close to delay 3 close.

APP instructions

APP installation:
1: The QR code on the scanner controller is downloaded and installed (not yet printed out).
2: Download and install (in application treasure search YETBLE).

Steps for usage:
1. Open APP. If Bluetooth is not open, you will be prompted to turn on Bluetooth. Enter the interface will search the device, click on the searched device, you can control, as shown below:

Establish connection
Open APP, auto search device as shown below, click on the found device, the following “curtain.”

          

Register APP
After the connection is successful, click the button and the following prompt appears. Press the code button on the controller and the indicator lights up.
Press the APP button again. The display is like the right interface. Indicates success.

     

Device renaming
Rename button. Click this button, the following interface appears, enter the name and click OK. After the naming, the right interface appears.

          

Interface introduction

1, access to AC AC-220V
2, then the battery power supply, DC12V
3, relay output, connected to the +12V after closed
4, +12V, when 1 connects AC-220V, here can output 12V 1A power to external power supply. When 1 is not connected to the power supply, the controller can also be powered by an external 12V input.
5. The negative terminal of the DC12V of the controller power supply.
6, the code button
7, power indicator
8, RF signal indicator, each received a code value flash oneTimes

Did you find apk for android? You can find new Free Android Games and apps.

write us

Maecenas malesuada elit lectus felis, malesuada ultricies. Curabitur et ligula. Ut molesie a, ultricies porta urna.Maecenas malesuada elit lectus felis, malesuada ultricies. Curabitur et ligula. Ut molesie a, ultricies porta urna.




May you like

YET2017All Rights ReseverdTechnical Support:Baiila